PeopleLink Wall Mount Speakers50W Wall Mount PA Speaker for Conference Rooms, Classrooms and Auditoriums

The PeopleLink Wall Mount Speaker is a two-way Wall Mount Speaker handling 50 Watts RMS, with a 5.25-inch polypropylene woofer and a 1-inch titanium dome tweeter. The two-driver design keeps a speaking voice intelligible while playback keeps its low end, which is why it suits Conference Rooms, Classrooms and Auditoriums alike. It mounts above head height, clear of boards, displays and furniture.

Yes. The enclosure is fully sealed, dustproof and water-resistant, and the grille is rust-resistant aluminium. That suits high-humidity rooms and halls that open to outside air between sessions. Heavy-duty terminal connectors hold the cable firmly at the wall rather than working loose over time.

Dual-axis brackets rotate 90 degrees vertically and 170 degrees horizontally, so each box can be pointed down at the seats rather than across glass or along a wall. In a wide Auditorium that lets each speaker cover its own block of seats, keeping level even from front to back. The same bracket handles both a pair beside a display and a distributed run along the side walls.

Coverage follows room shape rather than seat count alone: a Conference Room usually takes a pair either side of the display, while a Classroom or Auditorium is distributed along the walls so no row sits off axis. Each speaker handles 50 Watts RMS and aims 90 degrees vertically and 170 degrees horizontally, which lets a wide layout be covered from the wall line. Send your room dimensions and seating plan to a PeopleLink specialist for a speaker count.

Installation, service and support are delivered through PeopleLink Partners and Resellers in your region, with PeopleLink AV Specialists supporting them on sizing and integration. Wall mounting keeps the work off the ceiling, so an existing room can usually be fitted without opening the ceiling void.

Each speaker handles 50 Watts RMS and takes its cable run from a room amplifier or an audio processor. PeopleLink supplies Amplifiers and DSP units alongside them, which keeps the speaker load and the amplifier matched at the point of specification. Heavy-duty terminal connectors take the cable run from that rack.